fbpx
Anet 3D printer FAQ
September 19, 2020
3D Printing Filament Fight: PLA is overtaking ABS
September 21, 2020

How to Install J-Link-OB Driver

This document introduces how to install needed driver for the J-Link-OB to your PC.

Requirements:

PC: Windows 7 (64 bit)

Software: Setup_JLinkARM_V468.exe

Hardware Debug Downloader: J-Link-OB

Installation Procedures:

  1. Double click on ”Setup_JLinkARM_V468.exe ”

2. Click on “yes” to agree conditions

3. Click on “Next” to go on.

4. Select destination folder for installation.

5. Check the option “Install USB Driver for J-Link-OB with CDC”. And if wanted, you can also check the option “Add shortcuts to desktop”. Then click on “Next>” to go on.

6. Click on “Next>” to proceed to installation.

7.  Installation automatically goes on and detailed information will display step by step.

Follow prompt messages to ensure all renewals of required programing software (such as ARM, MDK, IAR…) are checked and click on “OK” to proceed.

8. Click on “Finish” to complete installation and exit.

9. Two icons stand for J-Link and J-Flash will appear on the desktop of your computer (if you select desktop shortcut at step 5 for installation).

It means that J-Link ARM and J-Flash Arm are successfully installed.

10. Connect J-Link-OB to the computer with a USB cable, it will remind to install a driver. And the driver can be seen in device manager section after being successfully installed.

Leave a Reply