fbpx
Anet 3d Printer
How to Print ABS on ET4 Series Printers
July 15, 2020

Introduction about N4 3d Printer

anet 3d printer

Hi guys, there goes another high-end model from Tomas Aceytuno to encourage you to enrich your print-days! Tomas introduced the process of printing a streetlight on Anet N4 Printer. Hope you all enjoy it!

Introduction about N4 3d Printer

First, loaded the file of the streetlight model you can learn its system, quolity and definition.

Introduction about N4 3d Printer

The structure of the model is separated into parts but we didn’t hurry to export it out for we had to drill some little holes that we later needed to cross the lamp wires through, and, of course, to add to dense supports also counts.

Introduction about N4 3d Printer

But during the process of slicing, it appeared to be slow. Never mind, you can go on Netfabb.com it will offer you solutions for various troubles caused by your models. And the problem of slicing slowly was handled quickly.

Introduction about N4 3d Printer

So the following was to export it into .N4 3d printer and patiently waited it to complete its work. It would not take long time cuz N4 prints several pieces at the same time. And then we took these parts out, removed the support and put them in the UV lamps to clean the resin remains. We had our pieces in quite detail.

Introduction about N4 3d Printer

Only left to use primer …

Introduction about N4 3d Printer

We changed resin into white one and printed out a piece of glass that perfectly fitted the groove. That was amazing, and finally mount a led lamp to our streetlamp and glue the parts.

Introduction about N4 3d Printer

Once everything was assembled and tested. It was time to just turn on the lights!

Introduction about N4 3d Printer

Leave a Reply